DCP Global
Previous product
Next product
 |
| ||||||||||||||
UsageSetseal 6 has been designed to overcome the drawbacks of many commonly used curing membranes which tend to provide a limited service life following the curing period of new concrete. It has good abrasion resistance and can be coated with certain coatings (please contact our Technical Department for specific applications). Materials Supplied18, 25 and 200 litres. StorageStore in closed containers above freezing (0°C) under dry, wellventilated warehouse conditions out of direct sunlight and away from naked flames or other sources of ignition. Shelf LifeAt least 12 months if stored in original containers Coverage5 - 12m² per litre per coat depending on the absorbency of the base. Standard
|
Technical Information
Application InstructionsSURFACE PREPARATION New concrete Setseal 6 should be applied immediately following power floating/finishing of the concrete surface ensuring all excess surface water has evaporated prior to application of the Setseal 6. Old concrete All surfaces must be clean, dry and free from oil and other such contaminants. MIXING Stir the Setseal 6 before use. APPLICATION New concrete Apply Setseal 6 by fine spray at a rate of 5 to 12 m² per litre. In severe drying conditions a second coat should be applied after 2 to 3 hours. Care should be taken to ensure complete coverage. Old concrete Apply Setseal 6 by squeegee, brush, spray or broom at a nominal rate of 5 to 10 m² per litre for the first coat, followed 5 to 8 hours afterwards by a second coat of 10 to 12 m² per litre. As the condition and therefore the porosity of concrete surfaces can differ so widely, it is recommended that a test application area be carried out to determine the precise coverage rate for each specific job. OVERCOATING Please contact our Technical Department for specific applications. WORKING CONDITIONSApplication range 5°C to 30°C. Do not apply in external situations where rain is likely to come into contact with the uncured Setseal 6. |
Download file
