Repcoat
FF

WATER BASED ACRYLIC AND DECORATIVE COATING

Advantages:

Protective barrier against chloride ions, carbon dioxide and water
Highly resistant to UV rays and weathering
Single component
Available in a wide range of decorative colours
Matt finish helping to hide irregularities
Colour stable

Description:

Repcoat FF is a ready for use, single component, acrylic based coating for external and internal applications over variety of concrete and masonry substrates.

Usage

Repcoat FF exhibit excellent long term weathering and UV resistance. Repcoat FF provides excellent protective and decorative fair face coating which can be used for a wide range of applications:
retaining walls, bridge abutments,
external concrete of storage tanks,
multistory buildings and villas,
pre-cast elements and concrete cladding,
commercial and Industrial complexes.

Materials Supplied

Repcoat FF is available in packs: 18 l.

Coverage

Depending on substrate, 80 -100 dry film thickness

0.18 - 0.22 l/ 1 m²/ 1 coat

Storage/ Shelf Life

Repcoat FF has a shelf life of 12 months if stored in proper conditions, at temperatures range between + 5°C and + 35 °C in its original unopened packing.

Keep from freezing!

Standard

EN 13300
EN 1504-2

Technical Information

Density	1.28 g/cm³
Liquid water permeability EN 1062-3:2008	< 0.1 kg / m².h^0.5
Bond strength by pull-off EN 1542:2002	> 0.5 N / mm²
Аdhesion EN ISO 4624:2004	> 2 N / mm²
Bond strength by pull-off after artificial aging at 70°C EN 1062-11:2003	≥ 0.8 N / mm²
Permeability, water- vapour transmission rate S_dEN ISO 7783:2011	Class II
Maximum grain size EN 1524:2013	< 100 Fine
Hiding power	86 g/m²
Wet scrub resistance at 200 cycles EN ISO 11998:2003	< 5 Class I
Film gloss at 85 °C EN ISO 2813:2001	< 5 Completely mat
Resistance to temperature shock EN 13687-5:2002	≥ 1.5 N / mm²with load movement
Permeability to CO₂ EN 1062-6:2005	> 50 m
Thermal cycles without deicing salts influence EN 1542:2002	≥ 2.0 N / mm²
Drying test EN ISO 9117-6	3 h

The technical data are specified at 23 ° C.

Application Information

SUBSTRATE PREPARATION

Surface preparation is very important to get the best performance; any surface to be coated must be clean, sound and free from oil, grease, curing compound, or any contamination. Any contaminants should be removed by light grit blasting.

Surfaces containing slight surface imperfection or blow-holes should be filled with a skim coat of cementitious repair mortar such as Cemfair PF. Deep defected areas should be repaired with cementitious products from DCP-Repair range.

APPLICATION
It is recommended to apply two coats of Repcoat FF at the stated rate of application.

The first coat can be diluted by up to 15% with clean water depending on the surface porosity.

The second coat can be applied within 2 hours depending on the ambient temperature. Coating can be carried out using airless spray machine, brush, or roller.