DCP Global
Previous product
Next product
 |
| ||||||||||||||||||||||||||||||
UsageGripdeck Wearcoat is designed to give excellent abrasion and non-slip characteristics when combined with Quartz or Gripdeck Aggregate. Gripdeck Wearcoat is primarily designed for use in car parks and offers excellent chemical resistance against petrol, battery acids, diesel, brake fluids, de-icing salts, etc. Materials Supplied5kg and 15kg pack sizes comprising resin base and hardener components StorageStore under dry warehouse conditions at a temperature between 15°C and 30°C. Shelf Life12 months in an unopened undamaged, sealed containers and stored under good conditions. CoverageThe coverage obtained will vary depending on the type and size of Aggregate used. As a guide, the coverage should be a minimum of 0.8Kg per m² on a Quartz Aggregate blind. 1.2Kg per m² on a Gripdeck Aggregate blind. |
Technical Information
* (do not apply if the ambient or floor temperature is to fall below 10°C during the first 24 hours) ** Medium aggregate blind Application InstructionsMIXING Gripdeck
Wearcoat comprises two components, a Resin Base and Hardener
which are supplied pre-weighed in the correct proportions. Under no
circumstances should part mixing be carried out. Taking care to ensure that the bottom and sides are thoroughly scraped, transfer the entire contents of both components into a separate mixing container. Using a power whisk attached to a slow speed electric drill, mix for approximately 3 minutes ensuring the mixing head is pushed around the sides and bottom of the mixing container. Transfer the contents into another container,scraping down and re-mixing for a further 2 minutes avoiding the entraining of excessive air until a uniform consistency is obtained. Important:
Never mix Gripdeck Wearcoat by hand as this could lead to areas of
uncured material. Premixing of the resin component will aid mixing. APPLICATION On completion of mixing immediately apply the Gripdeck Wearcoat by squeegee followed by a short / medium pile roller at the required rate onto the pre-swept blinded surface. NOTE: Gripdeck
Wearcoat is not colour stable and may discolour on ageing, especially the lighter colours. This will not adversely affect the performance of the system. Gripdeck Wearcoat Plus should be used where light colours or a UV colour stable system is required WORKING CONDITIONS Gripdeck Wearcoat should not be applied at temperatures less than 15°C. CLEANING Tools should be cleaned with suitable solvent immediately after use. HEALTH & SAFETY Consult the appropriate Material Safety Data Sheet before using Gripdeck Wearcoat . GENERAL GUIDANCE This data sheet is for general guidance purposes only and may contain information that is inappropriate for certain conditions of use. Accordingly, all recommendations and suggestions are made without guarantee. Further information is available from our Technical Department. |
Download file
