DCP Global
Previous product
Next product
 |
| ||||||||||||||||
UsageThe uniquely formulated properties of this tough membrane enable it to bridge new cracks opening up to 0.5mm without rupture, retaining the integrity of the coating and therefore preventing the ingress of water. Materials Supplied15kg pack size comprising resin base and hardener components StorageStore under dry warehouse conditions at a temperature between 10°C and 30°C. Shelf Life6 months in an unopened undamaged, sealed containers and stored under good conditions. CoverageThe coverage obtained will vary depending on the texture of the surface to which the Gripdeck Flexcoat is applied. As a guide, the coverage should be 1.0kg/m² when applied to a smooth primed surface. Existing construction joints and cracks should be overbanded with a 100mm wide ‘stripe coat’ of Gripdeck Flexcoat applied onto Gripdeck Primecoat E prior to general coating of the deck as these areas may be prone to greater movement. |
Technical Information
Application InstructionsSURFACE PREPARATION For
details please see the DCP Guide to Surface
Preparation. MIXING Gripdeck Flexcoat comprises two components, a Resin Base and Hardener which are supplied preweighed in the correct proportions. Under no circumstances should part mixing be carried out. Pre-mix the resin component with a power whisk attached to a slow speed electric drill for 1 minute prior to mixing both components. Taking
care to ensure that the bottom and sides are thoroughly drained, pour
the contents of the hardener portion into the resin container.
Using a power whisk attached to a slow speed electric drill, mix for
approximately 3 minutes ensuring the mixing head is pushed around the sides and bottom of the mixing container. Transfer the contents into another container, scraping down and re-mixing for a further 2 minutes avoiding the entraining of excessive air until a uniform consistency is obtained. Important: Never mix Gripdeck Flexcoat by hand as this could lead to areas of uncured material. Select an appropriate mixing container that will allow proper and efficient mixing. APPLICATION Immediately after mixing is complete, spread the Gripdeck Flexcoat onto the floor using a
squeegee and finish using a short or medium pile roller. Gripdeck Flexcoat is not colour stable and changes may be seen following application and before overcoating. This will not effect the properties of the Gripdeck Flexcoat in any way. OVERCOATING Gripdeck Primecoat (Body Coat) may be applied as soon as the Gripdeck Flexcoat becomes tack free. This should be undertaken within 30 hours of application. CLEANING Tools should be cleaned with Quickmast Solvent immediately after use. HEALTH & SAFETY Consult the appropriate Material Safety Data Sheet before using Gripdeck Flexcoat. GENERAL GUIDANCE This information is for general guidance purposes only and may contain information that is inappropriate for certain conditions of use. Accordingly, all recommendations and suggestions are made without guarantee. Further information is available from our Technical Department. |
Download file
