Thermofix
FOAM

POLYURETHANE BASED FOAM ADHESIVE FOR HEAT INSULATION PANELS

Advantages:

Excellent adhesion to all common construction substrates
Low thermal conductivity characteristics
Excellent acoustical properties
Can be over-coated by water based paints
High temperature resistance
Easy to apply

Description:

Thermofix Foam is a ready to use, one component moisture cure polyurethane foam adhesive. The unique composition of Thermofix Foam makes it ideally suitable to provide fast and high bonding strength to several type of construction substrates. The low thermal conductivity characteristic of Thermofix Foam makes it the best option to fix and fill the gaps between thermal insulation panels on the facades and foundations, thus it provides an integrated thermally insulated system.

Usage

For permanent fixing of insulation boards such as EPS, XPS, styrofoam and stone wool on facades and foundation.

Installation of roof tiles

Filling the joints between insulation boards

Isolation material for windows and doors frames

Materials Supplied

Thermofix Foam is available in 750 ml aerosol can

Storage

Thermofix Foam should be stored in vertical position in cool and dry conditions out of the direct sunlight at temperatures between 5°C and 30°C in its original cans.

Remarks

Do not leave the cured material exposed to UV radiation
Thermofix Foam cannot be used on Teflon, polyethylene and silicon surfaces
Do not apply at ambient temperature below -5°C or above 30°C.

Shelf Life

12 months in unopened cans stored under good conditions.

Technical Information @ 23°C

Specific gravity	27.5 ± 2.5 kg/m³
Tack free time	10 min
Trim time	30 min for 30 mm bead
Full cure	10 hr @ 23°C 24 hr @ 5°C
Adhesion to EPS board	≥ 300 KPa
Adhesion to XPS board	≥ 350 KPa
Tensile strength	≥ 10 MPa
Thermal conductivity	0.034 W/(m.K)
Fire class	B2
Service temperature	-45°C to 90°C

Application Information

SUBSTRATE PREPARATION
All surfaces must be clean from dust, loose particles and oil or any other contaminations that could affect the proper adhesion. Cover and protect all the adjacent surfaces before the application of Thermofix Foam. It is recommended to slightly damp the surfaces with water to enhance the expansion and curing properties especially at low humidity areas (less than 50% RH).

APPLICATION

Hold the foam can in upright position, fix the gun to the can by holding the gun handle with one hand, and turn the can with the other hand.

After fixing the gun, shake the can well to ensure proper mixing of the ingredients and maximum yielding. Apply the foam adhesive to insulation boards evenly in parallel to the sides of the insulation board (3 cm from the edge) and one stripe in the middle, parallel to the longest side (up to 25 cm between adhesive stripes).

After applying the foam adhesive to the insulation board wait 2 - 3 minutes and then press the board to the wall. The level of installed foam polystyrene boards can be adjusted within up to 5 minutes.

Download file

SDS

Thermofix FOAM

TDS

Thermofix FOAM GUN

How to

Connect with Don Construction Products

Don Construction Products Bulgaria EAD

Sales office

Monday - Friday: 9:00 - 17:30

Sofia 1582, Bulgaria

152 Prof. Tsvetan Lazarov blvd.

Techno Park Sofia

Tel.: +359 2 870 2782; +359 2 870 2761

info.bulgaria@dcp-int.com

Technical support

+359 2 870 27 82

Contact form

Get Contact Form

Name *
Email *
Phone
Address
Reason
Request
Security Code *